Haas
ST-10
Also applies to: ST-10Y, ST-15, ST-20, ST-25, ST-30
30 minutesEasyMTConnectFull OEE
What You Need
Cat6 Ethernet cableIncluded in kit
Flowstate CL260 edge nodeIncluded in kit
Customer provides:
- Network access
Physical Connection
- 1
Locate the Ethernet port
On the back of the control cabinet, find the RJ45 port labeled 'NET'.
- 2
Connect Ethernet cable
Run a Cat6 cable from the machine to the Flowstate edge node.
- 3
Set machine IP
Settings > Network. Static IP in the 10.0.100.x range.
Machine Configuration
- 1
Enable MDC
Setting 143 = ON.
Verification
- 1
Ping test
Ping from edge node. Response <1ms expected.
- 2
MTConnect XML
Browse to http://<ip>:5000/current — verify spindle, axis, status data.
- 3
Dashboard check
Machine appears in Flowstate within 60 seconds.
Available Metrics (7)
Execution mode
Spindle speed/load
Feed rate
Program name
Part count
Axis positions
Alarms
Don't have MTConnect access?
The universal CT clamp works on any machine — 15 minutes, zero configuration.
CT Clamp Fallback GuideReady to Connect?
Calculate what downtime is costing you, then get started.