Komatsu

H2F Servo Press

Also applies to: H1F, H2F, H4F

45 minutesModerateEtherNet/IPFull OEE

What You Need

Cat6 Ethernet cableIncluded in kit

Flowstate CL260 edge nodeIncluded in kit

Customer provides:

1
Locate EtherNet/IP module
The H2F has a Komatsu iCON controller with an EtherNet/IP communications module. Locate the RJ45 port on the iCON panel.
2
Connect Ethernet
Cat6 from the iCON EtherNet/IP port to the Flowstate edge node.
3
Set IP address
On the iCON touchscreen: System > Communications > EtherNet/IP > IP Address. Static IP in 10.0.100.x range.

1
Enable process monitoring
iCON controller: Setup > Data Output > enable tonnage, stroke position, and cycle data output via EtherNet/IP.
2
Configure force curve capture
Enable servo press force-vs-position curve logging. The iCON captures the full curve per stroke for quality verification.

1
EtherNet/IP scan
From the Flowstate edge node, run an EtherNet/IP identity scan. The press should appear as 'Komatsu H2F'.
2
Run test stroke
Execute a single stroke. Verify tonnage, position, and cycle time data appear in the Flowstate dashboard.

Tonnage (kN)

Stroke position (mm)

Cycle time (seconds)

Die temperature (C)

Strokes per minute (SPM)

Part count

Force curve (kN vs mm)

Servo motor current (A)

Don't have EtherNet/IP access?

The universal CT clamp works on any machine — 15 minutes, zero configuration.

Calculate what downtime is costing you, then get started.