Mazak
Integrex i-200
Also applies to: i-200S, i-300, i-400
60 minutesModerateMTConnectFull OEE
What You Need
Cat6 Ethernet cableIncluded in kit
Flowstate CL260 edge nodeIncluded in kit
Mazak SmartBox (if MAZATROL control)
Customer provides:
- SmartBox if older control
- Network access
Physical Connection
- 1
Check controller generation
SmoothAi controls have built-in MTConnect. Older MAZATROL controls need SmartBox.
- 2
Connect Ethernet
Direct Ethernet from machine (or SmartBox) to edge node.
- 3
Set IP address
Configure static IP on the machine or SmartBox.
Machine Configuration
- 1
Enable MTConnect
SmoothAi: Settings > Network > MTConnect = ON. MAZATROL: SmartBox handles translation.
Verification
- 1
Verify MTConnect feed
http://<ip>:5000/current should show multi-axis data.
Available Metrics (8)
Execution mode
Main + sub spindle speed/load
All axis positions
Feed rate
Program name
Part count
Tool data
Alarms
Don't have MTConnect access?
The universal CT clamp works on any machine — 15 minutes, zero configuration.
CT Clamp Fallback GuideReady to Connect?
Calculate what downtime is costing you, then get started.