Miller

Auto-Axcess 450

Also applies to: Auto-Axcess 300, Auto-Axcess 675

30 minutesModerateEtherNet/IPFull OEE

What You Need

Cat6 Ethernet cableIncluded in kit

Flowstate CL260 edge nodeIncluded in kit

Customer provides:

1
Locate network port
The Auto-Axcess 450 has an EtherNet/IP port on the rear (standard on all Auto-Axcess models for robotic integration).
2
Connect Ethernet
Cat6 from the rear Ethernet port to the Flowstate edge node.
3
Set IP address
Use the front panel: Setup > Network > IP Address. Or configure via Miller Insight Centerpoint software. Static IP in 10.0.100.x range.

1
Enable Insight data
In the configuration menu, enable weld data output. Miller Insight Centerpoint captures per-weld parameter data.
2
Set weld limits
Configure weld parameter limits (voltage/current/WFS windows) so the system flags out-of-spec welds automatically.

1
Test weld verification
Run a test weld. Verify voltage, current, and wire feed speed appear in the edge node data stream.
2
Dashboard check
Welder appears in Flowstate with weld parameters, duty cycle, and consumable usage.

Arc voltage (V)

Weld current (A)

Wire feed speed (in/min)

Gas flow rate (CFH)

Duty cycle (%)

Consumable usage (lbs wire)

Arc-on time (hours)

Weld fault/out-of-spec count

Don't have EtherNet/IP access?

The universal CT clamp works on any machine — 15 minutes, zero configuration.

Calculate what downtime is costing you, then get started.